Moped Repair Manual

You do not Mr. Goodwrench to perform routine maintenance or even small repairs on your moped.

In fact, following these simple steps, you can easily make your moped run smoother and more efficient ... It could even result in your moped running up to 10 km / h faster than before!

Here's what you do:

First, obviously make sure that the moped is cool ... do not try immediately after riding.

First you need a good wire brush to loosen and remove the carbon built.

We will be what is called decarbonization ... To do this, remove the exhaust pipe and muffler. You'll see a clip that connects the exhaust system ... it must be loosened.

Using a wire brush, thoroughly clean the inside of both the exhaust and muffler, making sure all residue is removed carbon released ... Remember that when you brush your muffler, what you can not go out with the brush can often be eliminated by shaking.

Finally, look over all the gas pipes and collars and all your connections and lines for carbon accumulation of carbon and other deposits.

More often than not, this simple procedure will do.

However, if the problem persists, you may need to consider cleaning the carburetor. If you find that you need to do this, please remember to keep all the carburetor compenents together ... it is not difficult at all to lose a piece.

If your moped has had trouble starting before and after following these steps you still have problems, you probably need to exchange candles.

Check your manual and / or troubleshooting guide if you are still experiencing mechanical problems.

For more tips, comments, survey results and a source for cheaper and mopeds on the Web, visit cheapscootersUK.com (if you're in the UK) or wildfiremopeds.com (U.S. and everwhere else.)

Thank you for reading!